Main > Main Forum

u360 long shaft

<< < (4/4)

Ummon:
No, Franco was sorta right, in that I kind of implied the use of a screw driver in turning, but quickly banked into travel, and then went into the rest. Seems mrclean got the message, though.

DaveStall:
This is well beside the point I suppose, but why would you want to turn the joystick like a screwdriver?  This would just be turning the joystick around the central axis which does not translate into any motion at all, it just spins the magnetic actuator.  If you are talking about a circular move (like in a fighting game), then you are not spinning the joystick like a screwdriver, you are moving it like a lever in several directions in rapid succession.  I'm sure the length adjustments we are talking about here are irrelevant, but you will be putting more torque on the workings of the stick in this case the longer the shaft is.

Dave

Ummon:
Just two similar ideas related to handle lenght, Dave. As implied by Franco, I should've compared prying with joystick travel.

Navigation

[0] Message Index

[*] Previous page

Go to full version