Main > Main Forum

Messy holes

(1/3) > >>

Dexter:
Hi all,

My first attempt at drilling through plastic on my net city cab has been a bit of a disaster. I need something to fit between the happ competition buttons and the plastic panel itself to hide the sloppy cuts (i.e. holes are slightly oval and you can see a gap when button is fitted.)

Any suggestions? I normally drill wood and get it spot on.

Dexter

somunny:
Dremel out the hole in a joystick washer?

SirPeale:
Not possible to start over?

Did you clamp the plexi down when you drilled?

Franco B:
Could make you some button bezels.  Any width/diameter/bore etc.


Visitor Q:
^^^ Those look nice.

Navigation

[0] Message Index

[#] Next page

Go to full version