Main > Main Forum
Mag Stik Plus Assembly Picture
Epyx:
I was carefully (well trying) to take apart the Mag Stik Plus but the force of the spring pushed the parts out before I could see the order...anyone have a picture of the order for re-assembly? I have two washers with teeth that I am the most concerned about (with regards to order).
Thanks in advance...
paulscade:
When I tool mine apart... I placed the parts on the table in order... hope this helps...
http://forum.arcadecontrols.com/index.php?topic=82241.msg891255#msg891255
I believe that the toothed washers were on the inside of the u shaped part.
Epyx:
Awesome. Thanks very much!
AndyWarne:
There is a full diagram on http://www.ultimarc.com/controldiags.html if you still need any info.
Andy
opt2not:
Hey Andy, do you sell the Mag Stik Plus replacement shafts alone? Without balltops?
I've got a few spare balltops I want to use, but I don't want to go through the hassle of trying to breakthrough the locktite seal of the balltop shafts you supply off your site.
Thanks!
Navigation
[0] Message Index
[#] Next page
Go to full version