Main > Main Forum

New GGG Product: Tron Joystick Handle - was: Soooo.....what's this thing worth?

<< < (5/39) > >>

Ummon:
So this is the repro unit he's been hinting at.

RayB:
Just the 2 shells?

$40 tops. (says the guy who paid $100 for a small plexiglass repro control panel!)  ;D

Havok:
I'd say $30.

And yes, make a Star Wars yoke and the circle will be complete.

CheffoJeffo:
IIRC, Specialty Plastics was selling them most recently for $60 shipped, but their website has once again vanished (this time due to AOL closing down the hosting service).

Necro:
I would say cost of manufacture plus 40% margin plus shipping.  Unless that comes out to be insanely expensive...or cheap. 

Then again...I'm in the biotech industry. :)

What my suggestion would be to have the handle alone plus accessories.  Have the custom accessories (i.e. a joystick ready to have the handle attached) at a higher margin than the handle.

...ok...I think maybe I'm getting into this too much. :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version