Main > Main Forum

Anyone need cam locks for your coin door or back door?

<< < (10/15) > >>

SirPeale:

--- Quote from: dtechlogic on September 24, 2009, 02:36:03 pm ---I don't have the key to them. I just obtain the cabinet less then a week and also the locks are busted on top part. i am going to unscrew them  today.
--- End quote ---

Measure them, they're measured by the threaded part.  I think they're 5/8".  I can see if I can get a couple of them while I'm @ it.

They also might be special because don't they have a lock bar or some kind of hasp?  It's been a while since I worked on a Neo Geo cab.

Pics are handy.

MKFan4Life:
Could use (2) for my Gauntlet Legends cab.  Should be Wells-Gardner Part #891-0547-00 double D cam lock.  Over/Under two entry coin door.  Can't measure the size, 'cause it came with no locks at all installed!  Can't find the dimensions for this part # online either.  Would it be a 7/8" length?  Door thickness appears to be 3/4" and where it shuts, the frame is close to 1" thick.  ???  What do you think? 

SirPeale:
As I stated above, over/under doors take a 7/8" lock.  I've never seen one that has not, anyway.

sayitaintjonas:
You can put me down for 12. One of my candy cabs needs 7 locks alone!

I'll get you all the sizes if this order goes through :)

SirPeale:

--- Quote from: sayitaintjonas on September 30, 2009, 09:56:19 am ---I'll get you all the sizes if this order goes through :)

--- End quote ---

The order is going thru.  I need those sizes!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version