Main > Main Forum

Best way to make pushbutton holes larger?

<< < (5/5)

_Iz-:

--- Quote from: ahofle on October 29, 2008, 12:57:43 pm ---
--- Quote from: saint on October 26, 2008, 11:36:07 am ---I would put a proper size hole in a piece of scrap wood, then clamp the scrap wood over the control panel with the holes properly lined up, then use a Fostner's bit. I would think that would work perfectly.

--- End quote ---

Ding ding ding ding!
This should also work with a hole saw bit, and maybe even a spade?

--- End quote ---

I like the router + template idea the best. It might work with a holesaw but it's an invitation to disaster to try it with a spade bit.

Navigation

[0] Message Index

[*] Previous page

Go to full version