Main > Main Forum
Pac-Drive in-game question
Ginsu Victim:
You have to run an external 12v source.
moose:
I've got the power supply from my pc available, as well as the original cab power supply. I just don't know how they set up the board(ledwiz) to allow for higher voltages.
Ginsu Victim:
LEDwiz? I can't tell you anything about that. I thought we were still talking about the Pacdrive.
moose:
I went with the LEDWiz 'cuz it has support in the front end I'm using right now.
Franco B:
It does help if you read the documentation ;)
I assume you have the LED Wiz v2? I only have the v1 but Ive just had a look at the v2 PDF for you.
As Randy said the LED Wiz v2 can handle loads upto 50v. The 32 outputs are split into four banks (1-8, 9-16, 17-24 and 25-32) and you can supply a different (or the same) voltage to each bank.
All you need to do is supply each bank with 12v from your PSU etc. This is assumming you are using all 32 outputs, e.g. if you are only using <16 LEDs just supply 12v to the first two banks and use outputs 1-16
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version