Main > Main Forum

Drilling through diamond plate

(1/1)

shmokes:
You know that stuff that owners of old jeeps put on the corners to cover up rust?  Well, I have a 1/8" thick sheet of it that I'm using for a component in my cab and I'll be damned if it isn't the hardest substance on earth.  I'm using a fairly decent corded drill and I just drill and drill and drill and barely make any progress.  Maybe I need to go pick up a cobalt bit or something.  I haven't even finished one hole yet and I need to make about 10 more. 

somunny:
Sounds like your bit is dull.  Go buy some good bits.  I would think high speed steel would be sufficient enough for what you're drilling but you may want to buy cobalt bits.  Also, I'd recommend marking each hole with a center punch before drilling (if you're not already).

edit:  Is it stainless diamond plate?  SS is not magnetic if you want to check.

shmokes:
Bit was dull.   :-[

After one and a half holes, which took an ungodly amount of time, the bit snapped.  So I popped in another identical bit (my bit set came with thee 1/8" bits) and in less time then the first one and a half I drilled the other nine and a half holes.   ;D  Live and learn.

Blanka:
Next time make a .dwg and have it water-cut!

Navigation

[0] Message Index

Go to full version