Main > Main Forum
Is anyone familiar with this trigger and 2 button joystick? M.A.C.H. 3, maybe?
(1/1)
TAG:
I picked this up on eBay recently for my (future) cab, since it was so much cheaper than the Happ heavy duty trigger stick that I had originally planned on getting.
My CP will be 3/4 in. MDO, and in looking at the joystick’s shaft, there’s about 1 3/8 in. between the bottom of the stick and the top of the base. That seems like it would be enough for me to mount the joystick under the panel with t-nuts/bolts, so long as I drill a hole large enough to allow the joystick to hit the switches at the bottom (I estimate about 1 1/2 in., maybe slightly larger). Does anyone see any potential problems with that idea? Personally, it seems like it would be too high if I mounted it on top of the panel.
Also, for anyone who’s familiar with this stick (which looks like the M.A.C.H. 3 stick on KLOV’s site), which buttons/connections do each of the 4 colored wires (orange, green, blue, and yellow) go to? I suppose ground/common is the most important, since I can always change the buttons from inside the games, but if anyone happens to know ahead of time, it would sure be a help to know.
Thanks for any help you can provide!
Ummon:
Yeah, though basically it's a general purpose flight stick. Happ sells them I think and there should be schematics on their site.
TAG:
--- Quote from: Ummon on August 08, 2008, 05:47:50 pm ---Yeah, though basically it's a general purpose flight stick. Happ sells them I think and there should be schematics on their site.
--- End quote ---
Thanks. I know there's a similar one available from Happ, and I know people have had some success mounting that one under the panel, so I figured this one would work the same.
While I've looked at the mounting and exploded views for that one, there's nothing there identifying which wires control which buttons. I imagine I'll just have to test them once I get ready to install, but I thought I'd ask around, first, just in case anyone had worked with this particular joystick before.
SavannahLion:
--- Quote from: TAG on August 08, 2008, 06:03:00 pm ---While I've looked at the mounting and exploded views for that one, there's nothing there identifying which wires control which buttons. I imagine I'll just have to test them once I get ready to install, but I thought I'd ask around, first, just in case anyone had worked with this particular joystick before.
--- End quote ---
If you have a multimeter, finding the pinout on something like this would be trivial.
You do have a multimeter... right?
TAG:
--- Quote from: SavannahLion on August 09, 2008, 01:40:58 am ---You do have a multimeter... right?
--- End quote ---
Yes, I do, but without anything wired up, I guess I didn't know that it could be used to figure out which wire went to which button. I'll take a look through those tutorials, thanks for the link.
Navigation
[0] Message Index
Go to full version