Main > Main Forum

Which quick disconnects?

(1/3) > >>

shmokes:
I used calipers to measure the width of the terminals and they are .2"  They are significantly bigger and smaller than .187" and .25" respectively.  Can someone help?  The battery is dead in my calipers, so I can't get a digital reading, but I can see the .2" mark, so I can't imagine that I'm just misreading it.

SirPeale:
Probably .250".  Got a picture? 

Jack Burton:
I bought quick disconnects from lowes that looked like the exact right size, but it turned out they are just a little bit too loose.  I don't think off the shelf quick disconnects are perfect fit for most microswitches.  Of course, you can do like I did and give them just a little bit, almost imperceptible squeeze, from a pair of pliers and they should fit on tight.

shmokes:
Here are some pics.  The first one shows the markings on one of the switches.  The second shows the measurement inside a pair of calipers.  The third is just a cool shot of a bug that let me get the camera unbelievably close (close enough for a macro shot) to it without flying away.  It was hypnotized by the light and heat of my work lamp.   :)


Edit: forgot to add pics

SirPeale:
I see no pictures.  And I just need to see the switch connector itself.

Navigation

[0] Message Index

[#] Next page

Go to full version