Main > Main Forum
Ultimarc IPAC 4 issue
mrserv0n:
I had this same problem with my ipac-4 , only with players three and four only it would not only be player 4s buttons but his stick as well, after unplugging it etc it works properly for awhile and then did it again, I never got the problem solver, I don't use that panel its in the garage now, I just have a 2 player ipac 2 machine and its been fine. Would be interested in hearing what solution you find.
I think its a problem with the ipac software or something cause sometimes I would open the software and click Program and it would say cannot program or something, so I would unplug it a few times until it excepted the programming and then it would work for a while and have to do it again
Umpa:
I just started having this same problem last night. Were you able to find a solution?
deadsoulz:
--- Quote from: Umpa on August 06, 2008, 09:13:03 pm ---I just started having this same problem last night. Were you able to find a solution?
--- End quote ---
I can't say wether its fixed 100% or not, but its not done it for me in a while, I found one of my cherry switches was the problem, it was stuck down, and I think it was constantly bombarding the IPAC P3/P4 side until it finally just freaks out. Open up your WinIPAC software and see if any of your switches are stuck or get stuck when you press them. Also double check your grounds.
Umpa:
I got it working by unplugging the cable from the I-pac and then plugging it back in and then rebooting. I hope this doesn't become a regular problem.
Thanks
miles2912:
Andy has a great trouble shooting guide on his web page. You plug in a keyboard and open notepad to do some tests. Works great and tells you where the problem is. That would be my first step.
http://www.ultimarc.com/ipac2.html
Towards the bottom is the troubleshooting.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version