Main > Main Forum

Keywiz Problem - Key stuck

<< < (2/3) > >>

spot:
update - i've attempted to connect to the keywiz via the kw uploader v2 program.

kw uploader just times out and cannot connect to it.

this has happened on my 2 pcs.

Randyt - if your out there help!!

csa3d:

--- Quote from: spot on July 07, 2008, 04:07:28 am ---update - i've attempted to connect to the keywiz via the kw uploader v2 program.

kw uploader just times out and cannot connect to it.

this has happened on my 2 pcs.

Randyt - if your out there help!!

--- End quote ---

Do you get an error that looks like this?  I'm also experiencing erratic mouse behavior, but haven't narrowed down if this is due to Mala or due to moving the mouse while the KeyWiz uploader is doing the "evil eye"effect.  Do you have a trackball hooked up as a mouse in your setup?

-csa

ringram:
sounds like a bridged solder joint on the board. Did you do any soldering on the board?

spot:
csa3d - no, the uploader just times out and doesn't connect.
also i don't have a mouse plugged in at all.
and i have tried it on my 2nd machine which doesn't have mala on it and the same occurs.

ringram - i haven't soldered the board at all - it just has screw terminals.

PS: i have bought another keywiz - but would like to see if this problem is fixable.

Havok:
Does this happen outside of Mala? I would fire up notepad and see if it does the same thing. Sure sounds though like it's a problem with the Keywiz unit itself. Is the main chip socketed? If so, try and re-seat it. I would also look on the board itself and see if you see any solder joints touching.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version