Main > Main Forum
Keywiz Problem - Key stuck
spot:
Hey guys,
just wiring up a keywiz into a cp for my mame cab.
when the pc loads to mala the down key is stuck and is scrolling downwards thru the menu.
it does this even when there are no sticks/ buttons wired into it.
i've tried it on 2 pcs and the 2nd test pc gets the kb error when a key is held down.
i also tried switching to the kb passthru and that stops the scrolling,
but when you switch it back to kw - the scrolling down starts again.
has this happened to anyone and they have fixed it?
or is my keywiz dead?
cheers!!
Havok:
Two things I would check: first off, double and triple check your wiring. Perhaps you have grounded something you shouldn't have.
Secondly - do you have a joystick connected to the upper UDLR? If not, leave the upper U disconnected.
Good luck!
If you still don't get it working, I would contact Randy - he's great with support.
spot:
thx for the quick reply.
i did re-check my wiring.
i also removed everything - so just the keywiz itself was plugged in.
and it still sticks the down key.
i have just email GGG too.
Jdurg:
Did you accidentally connect to the NC (Normally Closed) terminal instead of the NO (Normally Open)?
spot:
no, im using sanwa snap in buttons - so theres just 2 pins.
Navigation
[0] Message Index
[#] Next page
Go to full version