Main > Main Forum
YDKJ Controller (was: Aw crud.)
Chris:
Maybe I'll do what I would do with a regular arcade panel... put a thin sheet of plexi over the whole thing! Not only will that fix the holes but it'll also protect the overlay.
Franco B:
You want something like this. Give me a shout if you do. ;)
fjl:
Those washers are nice. But if you want it flat, I would put the washer underneath(glue it, weld it, whatever) fill the rest with bondo except the hole, sand to be flat and you should be good. The sanding part might damage the rest of the paint job though but if you don't care to repaint or whatever. But yeah...
Turnarcades:
You could use some 'liquid metal' like the stuff used to do minor car repairs on welds. Just scrape it underneath the lip you have cut to make a rough hole the size you have cut, then file and sandpaper it smooth and touch up the paint befoe popping the button back in.
Ummon:
--- Quote from: efjayel on June 28, 2008, 02:57:48 pm ---Those washers are nice. But if you want it flat, I would put the washer underneath(glue it, weld it, whatever) fill the rest with bondo except the hole, sand to be flat and you should be good.
--- End quote ---
Exactamundo.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version