Main > Main Forum
U360 Balltop Spinning Off
Ginsu Victim:
Never had this problem.
On the bottom of the shaft there's a slot for a flat head screwdriver.
Insert a screwdriver there and twist on the balltop tight.
Shouldn't be an issue after that.
Kajoq:
Blue Loctite is the solution you're looking for. I had the same problem with my Sanwas
mrjah:
Another vote for Loctite. I like it better than thread tape for various reasons, although both can be perfectly appropriate for a variety of uses.
Just don't accidentally use the permanent kind...
Havok:
Loctite is not the way to go - GinsuVictim said it. Just tighten it up with a flathead screwdriver, done.
Kajoq:
That doesn't always stay put. I did that numerous times to my sanwas (which I believe the u360 is somewhat based on) and they would still come undone. Put a drop of blue loctite and they're golden. And blue you can get off without breaking things.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version