Main > Main Forum
T-Molding Question
(1/1)
jholman76:
I'm building a cabinet and had a question about T-Molding.
When I put it in on the sides, I am starting on the back side and going all the way around to the front. My question is should I do the underside, where it sits on the ground, too? Would that be helpful to protect the plywood (im doing a furni-cab) from chipping? Or should I stick with rubber feet?
K Thx Bye
Joe
Level42:
Depends on the cab, but you can't use T-molding to let the cab rest on. It's not suitable to carry the weight, if you move the cab, it could very well get damaged or loose at least.
jholman76:
Ok, that is what I was questioning.. I have some rubber feet I will use on the bottom. I still plan on t-molding the back, top and front, just not the bottom..
Thanks!
Joe
Ginsu Victim:
Install leg levelers or wheels. Don't just let your cab sit on the floor.
As for the t-molding, it looks better (IMHO) to have it on bottom. I started in bottom middle, and worked it around until the ends met.
Navigation
[0] Message Index
Go to full version