Main > Main Forum

cutting the plexi quick question regarding the trackball

(1/2) > >>

clickhea:
i have my plexi lined up with the edges of my control panel, iam going to start by cutting out whats suppose to be the 3 inch hole for the trackball.  i have the trackball mounting plate in place so i know where the hole is suppose to be.  The problem is the 3 inch hole cutter i have is alot smaller than the hole in the mounting plate... whats going on here? i thought you were suppose to use a 3 inch hole cutter for the hole.

nuka1195:
It depends where you want the plexi to end up.

The mounting plates hole, fits around the lib of the trackball. so if you did not purchase the high lip trackball, you could cut the plexi smaller than the mounting plates hole.

I would recommend beveling the plexi to prevent your skin from pinching, Mountain (I beleive) has some real nice photos and descriptions of his trackball where he beveled it. he used the mounting plate as a guide for his router and it fits perfectly around the lip of the trackball. very nice job.

clickhea:
after some searching it seems like the highball requires a bigger hole


3 1/4

clickhea:
anyone know what size hole iam suppose to use for the u360 joysticks?

RoninEditor:
I just used the same 1 1/8" forstner bit that I used for my buttons and there's more than enough room for the throw... just drill reeeeeeally slowly at the end, if you gun it, it'll crack super easy (I practiced on scrap a lot before doing it). 

Navigation

[0] Message Index

[#] Next page

Go to full version