Main > Main Forum
What size hole saw needed to drill for cp buttons?
nick-g:
I am looking to add a piece of plexi over my control panel. What size hole saw will I need to drill the holes for normal arcade buttons? How about for joysticks?
u_rebelscum:
1 1/8"
Depending on if you bottom mounted, routed bottom mount, or top mount: 1 1/4", depends on how much you routed, and 1 1/8", respectively. (Assuming normal throw happs like joystick; other sticks might need more or less.)
The_Tyler_Black:
I perfer to use a 1/8th paddle bit. it makes it easier if your doing alot of holes!
solderguy1:
And start by drilling the backside out 1/3 of the way or so, then switch to the front and finish. It keeps the hole smoother.
Vash:
--- Quote from: solderguy1 on April 25, 2008, 08:36:25 pm ---And start by drilling the backside out 1/3 of the way or so, then switch to the front and finish. It keeps the hole smoother.
--- End quote ---
How do you make sure that it lines up on both sides?
Navigation
[0] Message Index
[#] Next page
Go to full version