Main > Main Forum
U360 Shift Function PROBLEM
(1/1)
koolmoecraig:
I have my U360 updated to the latest firmware(2.4) which is supposed to have shift functionality. I am having a weird problem.
Button #8(Violet Wire) on the U360 button harness is supposed to trigger shift mode when held down.
In Windows while doing a button test, the button I have hooked up to the #8 Violet wire shows up as it should as button #8.
When I am in Mame trying to configure buttons, that same button is showing up as Button #7. Therefore I obviously cannot use the shift function.
Anyone have any idea what would cause this???????
Ginsu Victim:
Test the other wires by touching them to the ground wire and see which one shows up as button 8. It could just be a wiring error on the manufacturer's part.
destructor:
In Windows bottons are numbered 1-8, in MAME 0-7.
Ginsu Victim:
^That is true.
koolmoecraig:
--- Quote from: destructor on April 25, 2008, 02:30:51 am ---In Windows bottons are numbered 1-8, in MAME 0-7.
--- End quote ---
Good call.
Thanks.
Navigation
[0] Message Index
Go to full version