Main > Main Forum
Ultimarc U360 Mod to add rotary function&Top-fire/LED
Stub:
It can, but I am wondering if I can go all the way and install 3way leds and a topfire. The tricolor to go with my 32 3way buttons.
Also it would remove any odd things happening as people handle the switch ground. If there were for instance a little bit of stray charge on someone this is connected to the ground for all the components. And they use the ground a the reference to the circuit.
I may be worrying over nothing, but I want to try to do it more professional.
Bender:
--- Quote from: Franco B on May 27, 2008, 01:46:50 pm ---Now come Bender, you know they will work, you don't need to test them ;) You just want to look at the pretty lights :)
--- End quote ---
AHHHHHHHH The PRettty Prettty lights!!!!!
I do love the pretty lights
Thanks, Guys
I hooked em up to 2 AA bateries and it worked great
Good news Pic of the top fire and LED version very SOON!
Bender:
hi Franco,
I'm doing my LED by your tutorial on Reroblast
all is well except the ball top
What diameter drill bit do you use to drill through the insert 5mm? and how deep do you past that? is it important for it to be just the added length of the led of is it ok if there is a little air above the led?
Thanks
Bender
Franco B:
Hi buddy, sorry for the late response, I haven't been on since yesterday.
Do you mean that the nuts in your ball tops have a solid end and you need to drill it out?
My ball tops were hollow but I had to drill some closed ones out for someone else. A 5mm bit will be fine. It doesnt matter if you drill a few millimeters past the solid end. In fact, it may help as when I made my shafts I made the threaded section a couple of mm short as other wise the ball top would not have screwed on all the way as the LED would have bottomed out in the ball. If you are using your stock shafts they will be 1.5mm longer so by drilling a little deeper it will give you a little more clearance for the LED to sit in.
Also, as the guide says don't forget to remove the shoulder from the LED otherwise it wont fit down the thread.
I don't know how you are holding your balls (ooo-er!) but make sure you don't damage them when you clamp them. I used a V vice with some rubber to protect my balls. ( :laugh2:)
Bender:
Yeah I'm real careful with my balls too!!!! ;)
something about putting my balls in a vice just isn't right no matter what the context :laugh2:
no really thanks for the Info!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version