Main > Main Forum

powerdrill holesaw

(1/2) > >>

noobofthecentury:
I bought a set of holesaw for my powerdrill online
and they cant fit to it
 :cry:

my power drill is ridgid
chuck capacity   1/16 inch to 3/8 inch

is chuck capacity the one I have to look out for?
I really thought all drill bits will fit =(

where to get a holesaw for 1 1/8 holes
for my power drill

im scared to buy a new one =(

severdhed:
i just bought an 18 piece holesaw set at a store called Harbor Freight Tools.  it was only $4.99.  i'm sure it isn't of the greatest quality, but for doing a few holes in a control panel it should be fine.  it seems as if they have stores all over the country, so if there is one in your area, you may want to check it out.

somunny:
Can you buy a 3/8" arbor?  The arbor is the piece with the drill bit on it that the hole saws screw onto.

Encryptor:
You should be able to buy a new chuck for your drill. They are not hard to change and can be bought at most hardware stores.

Encryptor

BORIStheBLADE:
I had to change the chuck on my cordless drill from a 3/8 to a 1/2 chuck. Its pretty easy and cheap too.

Navigation

[0] Message Index

[#] Next page

Go to full version