Main > Main Forum
Calling Ms Pac/Galaga owners *3 simple measurements needed pls*
spacies:
--- Quote from: coltchillin on March 24, 2008, 01:43:44 pm ---i guess ordering the side art from twobits would solve the panel shape problem :)
--- End quote ---
So does their art come pre-cut?
patrickl:
--- Quote from: spacies on March 24, 2008, 03:55:00 pm ---
--- Quote from: coltchillin on March 24, 2008, 01:43:44 pm ---i guess ordering the side art from twobits would solve the panel shape problem :)
--- End quote ---
So does their art come pre-cut?
--- End quote ---
If you look at the picture you can see where the artwork is and where it's painted blue.
I would assume it's pre-cut, but oversized.
spacies:
Yeah I see that.
I was blinded by that 'thing' it is stuck too. :laugh2:
I am going to use Joymonkeys drawing above I think.
coltchillin:
--- Quote from: spacies on March 24, 2008, 04:11:12 pm ---...I am going to use Joymonkeys drawing above I think.
--- End quote ---
you got it in .ai or something?
spacies:
--- Quote from: coltchillin on March 24, 2008, 05:44:28 pm ---
--- Quote from: spacies on March 24, 2008, 04:11:12 pm ---...I am going to use Joymonkeys drawing above I think.
--- End quote ---
you got it in .ai or something?
--- End quote ---
Yeah I do.
I created a new project with the correct horizontal and vertical size, inserted joymonkeys pic and stretched it to fit.
I have done this with every other good photo I could find so now I have 6 layers. When I flick through them or make them transparent they all line up with very slight differences in the art work which I suspect is from the factory.
I printed a full size cab out and this is what I came up with.
That is lying on my artwork.
This confirms I have the sizes right:
The MDF on the right is cut to Jakobuds specs:
This confirms those plans are wrong:
I am fairly happy now.
A bit more tweaking and I am ready to build.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version