Main > Main Forum
How do you guys have your pc power switch set up?
FrizzleFried:
I simply extended the switch from a cheap power strip to the top of my cab... I plugged the cab (monitor, marquee, etc) in to it as well as the PC. Set the PC to "start on power up" and you are good to go. With the flick of a switch everything comes on.
I did that on two cabs... on my juke cab I used a smart power strip and extended the power switch from the PC...when the PC turns on it turns on everything else including an amp about 10 feet away.
Kangum:
i wired a standard happ pushbutton under the control panel. holding the button down for 5 seconds turns my machine on or turns it off. i believe in the motherboard settings its called soft off.
waveryder:
I just set my PC to restart on power failure in the bios. That way when I switch on the cab the whole thing starts up.
Kaytrim:
I used the information at this website to hack my own smart strip. http://spystyle.arcadecontrols.com/01/index81.htm Then extended the power button from my computer to a Happ button on the outside of the cab.
Fozzy The Bear:
--- Quote from: Fozzy The Bear on March 06, 2008, 09:20:03 am ---AND whatever you do don't leave any drilling equipment in the house, or both cats will be behind the sofa drilling for oil before you get back!! :cheers:
--- End quote ---
HERE'S THE PROOF!!!! The truth about evil cats that everybody should know!
I thought everybody knew that you only get one of them purring to disguise the fact that the other one is behind the sofa drilling for oil!! See the attached expose picture!
Best Regards,
Julian (Fozzy The Bear)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version