Main > Main Forum

Dremcast controller hack

<< < (4/7) > >>

LoyalistRevolt:
Wow thanks you were a lot of help...anyway do I still need an I-pac for this? Also could tin wire work?

HaRuMaN:

--- Quote from: Kaytrim on March 05, 2008, 12:19:51 am ---Using an exacto knife will do the job.  Just don't be too rough, you want to leave the coper on the pad.

--- End quote ---

This is why I use a dremel + wire wheel at the lowest speed + light pressure.

Kaytrim:

--- Quote from: LoyalistRevolt on March 05, 2008, 07:34:50 am ---Wow thanks you were a lot of help...anyway do I still need an I-pac for this? Also could tin wire work?

--- End quote ---

If you are doing this for a dreamcast console only then no you don't need an I-Pac.  If you are building a control panel for a MAME machine then you will need an I-Pac, GP-Wiz or Key-Wiz to interface with the computer.  As long as the wire you use will hold solder then it should work.

TTFN
Kaytrim

LoyalistRevolt:
Ok I think I got it all I need to do it strip the controller to copper....then solder all the wires to there spot....then, connect them to the buttons and your done?

LoyalistRevolt:
Sorry for double posting but after I got all the material I pretty much knew what to do I just have a quick question is there anyway to check if your doing it right as you go?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version