Main > Main Forum

Best way to attach cable/wires to MDF

<< < (4/5) > >>

Fozzy The Bear:
There is of course an easier way than these fall off sticky backs.......  Just use an ordinary nail on cable clip... Then pass a cable tie through the loop of it.

Best Regards,
Julian (Fozzy The Bear)

Brax:
I prefer plastic p-clips. Mechanical fasteners are the way to go.

MaximRecoil:
Probably the simplest, easiest, and cheapest method is to put a staple where you want to attach the wire(s) to the wood (leave a little bit of the staple sticking up) and that gives you a point to attach the wires to the staple with a wire tie. That's how it was done from the factory in my Dynamo cabinets.

FhM:
While looking for the mounts I was thinking of I noticed a lot of the sticky ones had screw holes to but they dont look of particularly good quality. I did find these from here though that look good:

Avrus:

--- Quote from: Brax on February 02, 2008, 10:38:11 am ---I prefer plastic p-clips. Mechanical fasteners are the way to go.


--- End quote ---

Yup that's what I'm using and they work really well.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version