Main > Main Forum
convert u360 to magstick mount
emerica:
The U360's have a mount similar to Happ supers. You will need to drill some holes in the moutning plate of the U360. I ended up not drilling the holes b/c my panel was recessed from the bottom to fit the magstiks. I ended up taking everything apart and re-routing the bottom. :banghead:
If the bottom of your cp is not routed, then it would be easy for you to just drill the U360 plate. Also the plates are not identical and there would be plenty of modifcation to the magstik plate to make it fit the U360. I think that the magstik plate would be rendered useless to the magstik once modified.
urbecrisch:
I plan on selling my magsticks anyway, so I don't plan on drilling the mounting plates. My CP is not routed underneath so I'll cross that bridge once the U360's are in hand. Keep us posted on your layout/configuring.
mchay:
I ended up drilling the holes to fit the threaded bars, and it works perfectly :-)
Navigation
[0] Message Index
[*] Previous page
Go to full version