Main > Main Forum
J-PAC on a NEOGEO cab - JAMMA problem?
gaijin4life:
I have a J-PAC coming that I plan to put in a NEOGEO cabinet. I am reading that the NEOGEO multislot cabs don't use standard JAMMA and that plugging a JAMMA board into a NEOJAMMA (for lack of a better word) could cause problems.
My question is, can I plug the J-Pac directly into the NEOGEO cab JAMMA connector or do I need to use one of the NEO-to-JAMMA adapters that somehow standardize the NEOJAMMA connector? I don't want to blow out the J-PAC once it arrives...
Thanks in advance!
knave:
http://www.hardmvs.com/manuals/Jamma2NeoGeo4SlotPinout.pdf
gaijin4life:
Thanks for the chart link, but I guess my specific question was does the J-PAC have logic or soft settings to make this change in the firmware?
CheffoJeffo:
TMK, the Jpac has no programming to accept a NeoGeo multi-slot and remap the inputs.
The Jpac is JAMMA. The NeoGeo multislot is not (it is a 56-pin adapter, but it is not JAMMA).
If you want to put a Jpac in your MVS multislot cabinet, then you need to adjust the wiring in your cabinet (or get a JAMMA -> NeoGeo multi adapter ... NOT a NeoGeo multi -> JAMMA adapter).
gaijin4life:
--- Quote from: CheffoJeffo on January 28, 2008, 07:23:20 pm ---If you want to put a Jpac in your MVS multislot cabinet, then you need to adjust the wiring in your cabinet (or get a JAMMA -> NeoGeo multi adapter ... NOT a NeoGeo multi -> JAMMA adapter).
--- End quote ---
Thanks for the information. Do you have a recommendation for one of these type adapters that I'll put between the J-PAC and the NEOGEO wiring harness connector?
Navigation
[0] Message Index
[#] Next page
Go to full version