Main > Main Forum

ran into a problem need some input

<< < (2/7) > >>

vertygo:
make it to scale then  ?

Havok:
I think what clickhea is saying is that it's too late - the ole measure twice cut once opportunity is gone... No worries, however, how about something like this:



The red part being the control panel...

clickhea:
yeah thats pretty much what iam talking about havoc.. i took a pic so you guys can get a better idea



at the time i thought the slope would be fine since its my first cab, but now that iam up to the point where its time to measure out for the control panel i can tell its going to be way too much.


i was thinking about going your way havoc, do you think that would look retarded?

it may be my only way to fix this.


btw the pieces are dead even, iam taking the pic on an angle sitting on the floor so it looks off in the picture.

Spaz Monkey:
What's the distance between the two measurement points?

clickhea:

--- Quote from: Spaz Monkey on January 25, 2008, 09:31:26 pm ---What's the distance between the two measurement points?

--- End quote ---

14 inches

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version