Main > Main Forum
Drilling, Cutting, etc PlexiGlass
kelemvor:
What's the best way to cut plexiglass to cover a CP? I've used my table saw before and ended up with little plastic shards flying everywhere in my workshop. Also for drilling the holes too. Not sure if I can just drill them with my spade bit or if something else works better.
ANy advice would be great.
fixedpigs:
What's the best way to cut wood to make a CP? I've used my table saw before and ended up with sawdust flying everywhere in my workshop. Also for drilling the holes too. Not sure if I can just drill them with my spade bit or if something else works better.
ANy advice would be great.
leapinlew:
Router with a flush trim bit.
leapinlew:
Starting here and work your way through a couple posts on page 2.
http://forum.arcadecontrols.com/index.php?topic=55021.msg547383#msg547383
kelemvor:
Well, 2 out of 3 replies that are actually useful. Not too bad of a percentage I guess.
Have to go dig out the router I guess. Pretty sure I have a flush trim bit around somewhere. heh heh.
Thanks.
Navigation
[0] Message Index
[#] Next page
Go to full version