Main > Buy/Sell/Trade - non-retail

WTB: donkey kong 4 board pcb

<< < (2/2)

dirt:

--- Quote from: shilmover on December 16, 2007, 01:33:11 pm ---So you have the 3 power connectors? (P7, P9, P10) along with all the others (Control, Key, service, sound, monitor)?

If so, a 2-board will also work.  It just does not require the P7 connection to the sound board since the sound board is on one of the two boards.

I went through the same thing, but I can plug in my DKJr 2-board and my DK 4-board into an upright.

--- End quote ---
i did not know that. i'll have to check that out since i do have a working 2 board set from my other dk.

shilmover:
if the ribbon power cable is connected between the 2 boards, just disconnect it first.

RayB:
Ooooooooooooooooooohhhhh!!  :dizzy:

Navigation

[0] Message Index

[*] Previous page

Go to full version