Main > Main Forum

Wiring Ultimarc 360 harness to Happ buttons

<< < (2/2)

hellothere123:

--- Quote from: brock.sampson on December 05, 2007, 11:40:46 am ---I don't have a 360 yet, planning on them for my next project.  I found instructions on the ultimarc site

http://ultimarc.com/ultrastik_inst.html
Look for a section named "The connections for the 10-pin header are as below:"

You will have to daisy chain the black to the ground of all the switches.  Once you have it connected and is detected in control panels edit your mame.ini to enable joystick.  Start mame and hit tab to go to input (general) and set the buttons to the appropriate inputs.

My happ horizontal pushbuttons take .187 disconnects but some may take different sizes.

You can mount the joystick from the bottom but you may need the longer shafts.  You can also top mount them if you route a recess for them.  See this excellent write in the woodworking forum http://forum.arcadecontrols.com/index.php?topic=51235.0



--- End quote ---

thanks

Navigation

[0] Message Index

[*] Previous page

Go to full version