Main > Main Forum

Control Panel Overlay question

(1/3) > >>

Lakersfan:
I am going to order a CPO from mamemarquees but had a quick question before I placed my order... Since I will have Lexan on top of the overlay, do I need an adhesive backed CPO? I would think it wouldn't be necessary, but then again, this is my first cab.

Thanks gang.

leapinlew:

--- Quote from: Lakersfan on November 20, 2007, 12:38:40 am ---I am going to order a CPO from mamemarquees but had a quick question before I placed my order... Since I will have Lexan on top of the overlay, do I need an adhesive backed CPO? I would think it wouldn't be necessary, but then again, this is my first cab.

Thanks gang.

--- End quote ---

You don't have to, you can just get a glossy print. I prefer the polycarbonite and no lexan.

CheffoJeffo:

--- Quote from: leapinlew on November 20, 2007, 12:53:33 am ---I prefer the polycarbonite and no lexan.

--- End quote ---

 :applaud:

GAtekwriter:
I dont' know much about polycarb - I take it that it'll hold up to scratches and dings and such?  Do they print on the backside of the polycarb?

Jim

superbigjay:

--- Quote from: GAtekwriter on November 20, 2007, 08:40:28 am ---I dont' know much about polycarb - I take it that it'll hold up to scratches and dings and such?  Do they print on the backside of the polycarb?

Jim


--- End quote ---

They can do it, but they'll need to use a transparent film on which they print the mirrored image.
However, with this technique, you end up with no whites (which is transparent).  So the plexi
must be over a white uniform surface...

Navigation

[0] Message Index

[#] Next page

Go to full version