Main > Main Forum

IDE wiring for mini ipac

<< < (2/3) > >>

ratzz:
Thanks for that guys  ... I was beginning to think i'd asked something really dumb!!

Yea, I plan to use one of those blocks to connect things to. In fact, there is a diagram for this on the Ultimarc website, so I assumed it'd been done before, and it's also mentioned about using an IDE connection.

I, too, have loads of these leads spare from previos PC builds, and I'm in no rush to finish my cab.

Ratzz  :cheers: :cheers:

Dervacumen:
I'm about to begin wiring my own harness as well.  I found the diagram on Andy's site a bit confusing so I put this one together.  Can someone confirm I have the pin outs correct?

knave:
I think there's an additional ground at pin 40.  Unless this is just for the trackball stuff...

Here take a look:

Minipac wiring

ratzz:
Does this help any?

I've removed the wire colours and moved the pin numbers on to the line.

BobA:
Something looks wrong with the spinner wiring.   For the trackball the 5V and GND are shown as not going back to the minipac.  Just the signal wires are drawn in.   On the spinner 2 wires are drawn in but the 5V and GND are marked differently and GND is shown drawn in and going to the minipac.   There was a discussion of this earlier and I do not remember what the resolution was.    Since a spinner needs 2 signals plus a gnd and 5V it way it is shown the blue wire (2) does not go anywhere so something is incorrect.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version