Main > Main Forum

Octagonal restrictor for JLW-UM-8?

<< < (2/3) > >>

Kaytrim:
bite the bullet and get some JLF sticks with the octagonal restrictor, you'll be glad you did.

bluevolume:

--- Quote from: Kaytrim on October 25, 2007, 03:40:00 pm ---bite the bullet and get some JLF sticks with the octagonal restrictor, you'll be glad you did.

--- End quote ---
Not possible.  I JUST built my panel with the other joysticks, and I would have to trash the overlay to accomodate the odd size of the JLF sticks.

Kaytrim:
I am guessing that the overlay is stuck in place then?  Let me see a pic of the top and bottom of the panel.  Maybe I can come up with a solution.

bluevolume:
Here's the link to my project thread:
http://forum.arcadecontrols.com/index.php?topic=70295.0

The last few entires have lots of pics of the control panel.

Kaytrim:
Ok Let's see if we can save the Sabercade.  Take and get the measurements from front to back screws and from side to side.  Do it in millimeters.  When I get home I'll check one of the JLF mounting plates that I have.  If I am reading the Sawna catalog right they could be a straight swap.  With the way you have them mounted using nuts and bolts as long as the mounting plates match up I don't see why you couldn't do the swap.  You may even be able to use the bat tops from the JLM on the JLF shafts.  LizardLick sells adapters that allow this.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version