Main > Main Forum
Questions on Book version of cabinet
GAtekwriter:
I'm a little stumped (mainly tired) on some issues that I hope some of you might be able to help me with -
1. I've mounted the speaker shelf but I cannot seem to find where the book specifies where the front edge of the speaker shelf should rest... how far back? It's angled, so does the upper corner have to touch the 3/4" inch standard inset or the bottom edge? I know this is important because it'll affect the marquee placement.
2. The book states that the monitor shelf should be flush with the front of the cabinet and says to look at figure 22 - but in the figure, the monitor shelf is recessed 3/4" - I'm guessing flush, but maybe I'm not thinking far enough ahead and there's a reason for the recess.
Thanks! Pic below of the cab's current status.
Jim
javeryh:
Hmmm... your speaker shelf looks a little too angled to me - I installed my speaker panel (pretty much) parallel to the top panel - the marquee light goes up there too and it makes it easy to accept the brackets for installing the marquee. It looks like you could easily put something in there though.
GAtekwriter:
Yeah, I thought it was a bit steep, too... but after re-reading the book and looking at the pictures (including the Mars Invasion project that also follows the book), the speaker shelf appears to be inserted correctly. Luckily, I'm going to be using an LCD so I'm not worried about space.
JIm
Xam:
That's roughly the same angle as mine.
I mounted my speaker shelf in line with the board on top of the cab. I ran into the same issue when building mine.
GAtekwriter:
Xam,
Did you pull the monitor shelf all the way to the front, flush with the front edges of the cab's sides OR did you recess it 3/4" inch?
Jim
Navigation
[0] Message Index
[#] Next page
Go to full version