Main > Main Forum

Control Panel Connection

(1/4) > >>

FrizzleFried:
My new MAME project is such a beast that it will not fit through a regular door without the control panel removed.  In order to accommodate this requirement I will need to wire in some sort of connection interface.

I was thinking of just going with a hard drive cable,  however,  if I did that,  I would need to find a cable that had a FEMALE end as opposed to a regular MALE hard drive cable end.

Does anyone know where I can find such a thing? 

...or perhaps someone has a better idea as far as a connection interface? 

Thanks!

Dudeman:
I'm not sure how many connections you need, but I'm using these:

http://tinyurl.com/3ceaqx

http://tinyurl.com/2j493s

There are solder ones too.

mountain:

--- Quote from: Dudeman on October 04, 2007, 07:30:24 pm ---I'm not sure how many connections you need, but I'm using these:

http://tinyurl.com/3ceaqx

http://tinyurl.com/2j493s

There are solder ones too.

--- End quote ---

Frizzle,
This is what I used as well. If you aren't up to soldering them you can get these plugs with Molex pins that you just crimp.

FrizzleFried:
Do you order online or do you drop by your local RadioCrap?  Do they have much of a selection at the B&M?

Dudeman:
I got it at the local store. They usually have these in the area with the components.

Been looking and haven't see a male 40 pin connector for a HD cable.

Navigation

[0] Message Index

[#] Next page

Go to full version