Main > Main Forum

Need to print decals for cabinet

(1/4) > >>

bluevolume:
I've been trying to figure out how to get some decals for the side of my Sabrecade cabinet.  I need a large decal for the sides, and a few smaller ones for the front.  I have a good inkjet printer at home, and access to a large-format one at work.  What media would work well for this?  Can you buy large photo paper with adhesive on the back?  Is that even a good idea?

I looked into having this done in vinyl, but the shop said that it would be like 5 layers and it would be expensive.  Kinkos is a no-go, they will not print the logos (at least the lady I talked to at the counter woudln't do it).

Also, I would like to print a sheet to put beneath the plexi on my control panel.  What is a good method for that?

Thanks!

SlammedNiss:

--- Quote from: bluevolume on September 19, 2007, 01:47:01 pm --- I have a good inkjet printer at home, and access to a large-format one at work.  What media would work well for this? 

--- End quote ---

What material are they using for the one at work? Is it just printing on paper?

bluevolume:
As far as I know it is a roll of plain paper.  I could buy whatever media is needed.

mcfreak:
I've had my eye on this for a while: http://www.atlex.com/paper/adhesive_vinyl.htm
We have a large plotter/ink jet at work as well.

I haven't made the decision to do it yet but I have 4 cabinets to do so I would think it would come out cheaper.

markrvp:
Here is what I use. 

http://www.lexjet.com/lexjet/product_disp.asp?dept%5Fid=12077&pf%5Fid=AQPSRM

Navigation

[0] Message Index

[#] Next page

Go to full version