Main > Main Forum
Plastic bezel for 27" Betson?
divemaster127:
oh sorry bezel
dm
Lakersfan:
Another question regarding the Happ 27" bezel ... Is it made to be trimmed around the inside? The reason I'm asking is because I had to create my own monitor brackets and although right now it looks just fine with the monitor in place, I'd hate to pay for the bezel and find out the monitor is sitting too far forward or too deep.
AMDman13:
The inside of the bezel will fit the monitor perfect. The outside of the bezel will need to be trimmed to fit the width dimensions of your cab.
I waited to mount my Betson until I had the bezel so that I could make sure that my bezel and plexi would be a perfect 3/4" recess from the front of the cab.. In other words I fit the monitor to the bezel and not the bezel to the monitor.
Lakersfan:
Thanks marlborroman!
Ehhhh... that's what I should have done. But I didn't even consider the bezel at the time I was creating my brackets...
Ok, so basically by your post I'm gathering that I need a 3/4 inch recess from the monitor to the place where the bezel sides will lay? Where on the monitor are you measuring the 3/4 inch from? The middle of the monitor or the sides?
Thanks!!
Navigation
[0] Message Index
[*] Previous page
Go to full version