Main > Main Forum

Powering Up and Down with Surge Protector

(1/2) > >>

codeena:
Hi all,

Just wondering if it's perfectly safe to power up/down components like an arcade monitor, speakers, etc. with the button on a standard surge protector (not like a Smartstrip or Sears Auto Power Center). In other words, I'd leave the power button activated on the monitor, speakers, etc. but use the surge protector's switch to power them up and down. I don't want to risk any damage.

Thanks in advance!

Green Giant:
That would be no different than the smartstrip.  Just make sure you shutdown your computer first and then shutoff the powerstrip.

Malenko:
thats how I wired mine.

1 surge protector(A) comes into the cabinet, the computer and another surge protector(B) is plugged into it. Surge protector A is always on, so the PC is always on. I flip the switch on the second surge protector (B) to power on the monitor speakers and marquee

sac01:
I did that on my first cabinet.  I removed the switch from the powerstrip, lengthened the wires going to it and mounted the switch into a hole in the side of the cab, then I just hung the 6 outlet strip inside the cab and plugged everything into it.  I mounted a seperate reset/power off button near the switch and connected that to the MB.  Works great to this day, n ice cheap and simple

miles2912:

--- Quote from: sac01 on September 11, 2007, 05:03:58 pm ---I did that on my first cabinet.  I removed the switch from the powerstrip, lengthened the wires going to it and mounted the switch into a hole in the side of the cab, then I just hung the 6 outlet strip inside the cab and plugged everything into it.  I mounted a seperate reset/power off button near the switch and connected that to the MB.  Works great to this day, n ice cheap and simple

--- End quote ---

Did the exact same thing on my cab.  Works great.

Navigation

[0] Message Index

[#] Next page

Go to full version