Main > Main Forum
How to map mouse buttons.
BobA:
If you got the USB interface with your Elec Ice TB from GGG then it is a Opti wiz and has pins to connect the mouse buttons to.
pboreham:
Thanks Bob - I've got my docs for the TT2 spinner, but not the Trackball. The Spinner shows where to connect the mouse buttons :banghead: I assume the Trackball is the same (I cannot look at the moment as everyone is asleep!).
How do you connect the wires though? Do you have to solder, or does it have screw points?
Thanks again for your help.
BobA:
I am not 100 percent sure as I do not have the doc or the interface. But usually there are either solder holes or pins to connect to. Since GGG sells a harness I assume pins but they may sell them without the pins and call it the solderless version. Solderless means pins that the black connectors slip over and solder means holes that you can solder the wires to.
Hope that hleps
SavannahLion:
If you're connecting both spinner and trackball at the same time, you don't really need to connect the same buttons to both. I believe connecting buttons to one should suffice.
Navigation
[0] Message Index
[*] Previous page
Go to full version