Main > Main Forum
Ready to put Trackball into my cab, concerns/ questions
BobA:
Look at Buy/Sell where you will find the same item for alot less then Happs charges.
It will still be a tight fit what about a smaller trackball?
mrserv0n:
Well Boba, I know 3" is the standard and I have played with those, I have never used/seen a 2 1/4 in person so I don't know if it would be just as good or not.. Judging by the dimensions it knocks off about .75-.85 of an inch in both Length and width, I have to grab the measure tab and see what I am working with..
Ok I have I basically have 5.5" Length and 7" width..
Judging by the diagram without modding into my coin slots I am about .3 in. short of the 3" ball.. The 2 1/4 is only 4.5inch radius so that should fit nice and smooth.. Hopefully the size of the ball doesn't disappointin performance ..
xmenxmen:
Looking at your cabinet, have you consider getting a coin door instead. The metal blank door that you have at the bottom can be taken out and a coin door can take it's place. This would free up quite a bit of room. The replacement coin door would just be your over under Happ coin door.
Navigation
[0] Message Index
[*] Previous page
Go to full version