Main > Main Forum

My CP Layout, Spinner + drill/router bits questions

<< < (4/5) > >>

ARTIFACT:
QUICK QUESTION:

Is 1 1/8 hole saw a standard size?

My neighbor has 2 cases with different hole saw kits - he lent me a 3" one for the trackball, but didn't have 1 1/8" ... the closest was 1 1/4"

I'm going to call around to see

javeryh:
It's a very common size - look for a foerstner bit or a spade bit (it's a little small for a hole saw but I've seen them).

ARTIFACT:
got it from the store!

thanks

ARTIFACT:
i built a mockup of my CP on a scrap board :)

i will post pics in my project thread - lets take this there from here.

thanks everyone for your support and help!

ARTIFACT:
Continuation of the CP of my cab project is here:
http://forum.arcadecontrols.com/index.php?topic=68794.0

(thanks again everyone)

MOCKUP BUILT THANKS TO THE HELP HERE:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version