Main > Software Forum
Mame Hooker 2.0 Released!
brock.sampson:
So I made a very simple jpg file 800x600 single color with some text in the middle. Same results loads fine the first time only partially the second. Also as I noted in my original post I'm able to recreate this problem without using mame just using the test command within mamehooker. I also tried adding a wat 1000 before the lds command, same results. Below are the entire contents of the dis file which doesn't seem to be very large to me.
gt2k.dis
[Layout]
x=0
y=-768
width=800
height=600
image=gt2k.jpg
I set the resolution all the way down to 640x480 on my secondary monitor, made a 640x480 image, and I still get a partial image on second and subsequent loads. I did find one thing interesting if I make my secondary monitor primary it will display the correct image everytime. Its only when I try to push the image to the secondary monitor it cuts it off. Let me know if you want me to try anything else.
Thanks,
Popcorrin:
I was using mamehooker to light some keyboard leds on mamestart and it works great if you only want to light one of them. I tried to light two of them but it would only light the first one in the script. I followed the instructions in the readme for multiple commands and I could not get it to work. Here is what I had.
MameStart=kbd 1 1, kbd 2 1
The directions seemed pretty straight forward so I didn't think I missed anything.
Also, I was wondering if the recent changes in mame would mess mamehooker up at all, Multiple keyboards?
Thanks
Howard_Casto:
You've got a syntax error..
It should be:
kbd 1 1,kbd 2 1
Note the lack of a space.....
I'll put a bit of error handling in the next build to make it a little more user-friendly.
Popcorrin:
That did the trick. Thanks
Howard_Casto:
Just for the record, mame's input changes never effect mamehooker. Only output changes do. :)
New release is in the pipe, sit tight!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version