Main > Main Forum
Coin Door Help - AKA - I'm dumb
iamnaeth:
I'm having a little trouble figuring out how this coin door mechanism A) fits in the coin door and B) can send a trigger saying a coin passed through. I order a Happs over/under coin door from ebay and since I didn't read the listing thoroughly enough, it came without coin mechs. I ordered some mechs from someone on this forum and I seem to be too dumb to figure it out....either that or I have the wrong mech. So without further ado (adieu?):
Picture 1: The coin door without any mech in it....you may notice the return bin is missing from one of the sides....that's be cause I took it it out in effort to fit the mech in.
Picture 2: A blurry picture (sorry) of my mech.
Picture 3: The coin door with the mech in place on the side without the return bin. Like I said before, it was the only way I could get it to fit.
Picture 4: This is a side view trying to show that the return bin is in the way. What you're seeing is the return bin on the other side of the mech in place.
Picture 5: Just another picture.
So....what am I doing wrong? Do I need to order new mechs? If so, what should I order to be able to handle all change (I wanna use it like a piggy box) and tokens (ordered some BYOAC tokens).
Thanks!
Nathan
RayB:
See in your last picture, on the right, the "arc" shaped cut out hole? There should be a wire and microswitch mounted on the other side of that. Coin falls out of the mech and hits the switch wire on its way down to th ecoin box.
iamnaeth:
Ahh, that makes sense about the microswitch. Any clues why it won't fit? Is that the wrong type of mech?
asmida:
I can't tell for certain, but It almost looks like those mechs will fit. The plastic should go under the spots for the connecting screws.
Line up the arrows in my drawing.
asmida:
http://forum.arcadecontrols.com/index.php?board=2;action=display;threadid=19200
As far as All-in one mechs- check out the above thread.
Navigation
[0] Message Index
[#] Next page
Go to full version