Main > Main Forum
What Type Of Resistor Is Needed?
lettuce:
What type of resistor will i need if i want to get a 12v current down to a 5v? I want to connect my credit board up to my I-PAC, but the credit requires a 12v supply, so i need to add a resistor to the wire that is connected to the I-PAC and the pulse input on the Credit Board, to get the 12v down to a 5v so it doesnt fry the I-PAC
Angry_Radish:
I'd use a voltage regulator, not a resistor.
They are quite cheap at radioshack and other electronics stores.
:cheers:
BobA:
You need to invert the signal as well as isolate 12V from 5V. The ipac needs a ground to indicate a contact closure.
Use an NPN transistor and a 1000 ohm 1/4 watt resistor to make the following.
lettuce:
I only have a very basic skill in wiring and soldering. Can you use simpleton terms by any chance?
Angry_Radish:
Doh, missed the pulse bit, tnx :cheers:
--- Quote from: BobA on July 15, 2007, 09:54:49 am ---You need to invert the signal as well as isolate 12V from 5V. The ipac needs a ground to indicate a contact closure.
Use an NPN transistor and a 1000 ohm 1/4 watt resistor to make the following.
--- End quote ---
Navigation
[0] Message Index
[#] Next page
Go to full version