Main > Main Forum

Need help troubleshooting 3" Happ Trackball

<< < (6/8) > >>

nickbuol:
ARGH!!!  In my testing, I managed to accidentally pull the red input wire out of its socket in the plug that attaches the USB/PS2 cable to the first board...  I don't think that it was loose.  I had the board lightly attached to a rubberized "vice" like grip on my work bench, and didn't see that it was snagged when I grabbed it quickly and left the workbench.  I felt a good little pull, and then saw the loose wire.  Still not EXACTLY sure what it snagged on, but ARGH I am getting frustrated.   Now to figure out if I can fix that easily...

rescue161:
That is difinitely not cool.  Hope you can get it fixed (at least that part) so you can figure out what's really wrong with it.

nickbuol:
I got it back together.  Any thoughts on what else to try, or should I just get an order placed for replacement boards?

Thanks!

rescue161:
To do any further troubleshooting I'd need to actually see the board.  You're going to better off buying the new boards from divemaster127.  That's a good deal.

To troubleshoot further, you'd need an oscilloscope to "see" if the timing on pins 6 through 9 is right.

nickbuol:
Hey, thanks for your help up to this point.  I just fired off a PM to divemaster127 about the boards...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version