Main > Main Forum

No this is not what I wanted to happen

(1/6) > >>

smac666:
Hmmm,

Just doing some finishing touches to a minor cab refurbishment last night and was removing the CP plexi to clean underneath when I knocked the wood part of the CP through its opening and into the cabinet. Tried to turn the game on later after I had finished and nothing but a blue screen.

Pulled the back off and found the following.
Noooo.jpg

Looks like the CP caught one (4.7K ohm) resistor bank (I am assuming thats what it is) and smashed the other.

Not happy :(

So to fix it, I'm guessing I need to replace both the resistors with new ones. They seem to be a 9 pin configuration. Are these common and anyone know a reliable place to get two.

Thanks
Steve

rovingmind:
if the SIP resistor has a part number on it, see if ECG has a replacement part for it

ChadTower:

If it is not labeled, get the schematic, and pull the part number from there.

smac666:
Ok,

I looked at the resistor and it doesn't appear to have a part number on it, nuts

I have looked around, Mike's Arcade, Arcade Archive, ggdb, etc and can't find a schematic for the game.

If anyone knows where I can find a schematic for Capcom's Willow I would appreciate it if they could let me know. Otherwise if someone has a schematic could they please tell me the part number for the Resistor. They are on the top board and are tagged 1E and RA2 respectively on the Board itself.

Thanks
Steve

rovingmind:
thats a sweet game,

maybe you could ask this guy?  scroll down he has shots of the game and parts, if its his game he has the manual.  It shows in a picture of the parts kit.

Navigation

[0] Message Index

[#] Next page

Go to full version