Main > Main Forum
configure right and left mouse buttons with GGG EI trackball
moriartyds:
Not only that, but it frees up your IPAC inputs for other buttons/functions.
squirrellydw:
I'm back.....I have the GGG electric ice trackball USB, how do I wire two buttons to it to use as mouse buttons? I am at work right now so I can't look at it. Are there inputs on it somewhere?
thanks
fjl:
Pretty simple.
ON the bottom of your ICe Trackball, you will find a circuit board with various pins. Right below the Circuit chip it says, M-Buttons and has four pins. Ground L M R.
Simply get a jumper and connect accordingly. Ground to L = Left mouse button. Ground to M = Middle mouse button, etc.
squirrellydw:
what do you mean by a jumper, as in what you use on a hard drive or mother board to set configurations?
RandyT:
The "G" pin is common to all of the switches and the L, M and R pins are LEFT , MIDDLE and RIGHT mouse buttons respectively. You would wire the buttons just like you would with any other interface.
RandyT
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version