Main > Main Forum
Opti-wiz Z Axis
u_rebelscum:
--- Quote from: RayB on May 16, 2007, 11:44:05 am ---A mousewheel is typically very low resolution.
--- End quote ---
Why do you think that this is causing the problem? Maybe if he was hacking a mouse, but he's using an optiwiz which has as good a Z axis as X & Y.
--- Quote ---Try it on one of the other axis first and see if the problem is the same.
--- End quote ---
In general, it's good practice to try another axis and if possible a different sensor board, if you don't know what the problem is, no matter if the problem axis is Z or X or Y.
Navigation
[0] Message Index
[*] Previous page
Go to full version