Main > Main Forum
Best way to wire Ipac? Solder?
dndcollect:
here is a dumb question, what is that red thing and how do you use it? i have a bag of them.
me= :dizzy:
NoOne=NBA=:
They are quick disconnects.
You crimp them on to the end of your wires, and then they just push onto the tabs on the microswitches.
When you need to put in a new switch, you can quickly disconnect the wires, and replace the switch.
ahofle:
I had this problem a while back and it turned out to be microswitch 'bounce'. You can test this by taking a switch that doesn't exhibit the double behavior and swap it with a 'suspect' switch. If it stops double-pressing, then it's likely the switch.
dndcollect:
--- Quote from: NoOne=NBA= on May 09, 2007, 06:36:48 pm ---They are quick disconnects.
You crimp them on to the end of your wires, and then they just push onto the tabs on the microswitches.
When you need to put in a new switch, you can quickly disconnect the wires, and replace the switch.
--- End quote ---
so do i strip the wires, put them in a hole and then crimp it?
also if i am daisy chaining do i twist 2 together and then crimp?
NoOne=NBA=:
--- Quote from: dndcollect on May 09, 2007, 06:57:57 pm ---so do i strip the wires, put them in a hole and then crimp it?
also if i am daisy chaining do i twist 2 together and then crimp?
--- End quote ---
Yes, and yes.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version